Is an innovative leader in the developing and manufacturing of Industrial & Agricultural new materials and molecular sieve series products
Each Molecular Sieve packet contains 12.5 grams of Molecular Sieve desiccant. Using the proper amount of Molecular Sieve is important for optimum storage results. Never use more than the recommended amount.
Molecular Sieve can be introduced at any stage of film storage, but is most effective when introduced at the earliest opportunity (after lab processing and before storage).
the inclusion of Molecular Sieve with processed motion picture film in a sealed container has the ability to extend the life of the dye images and film support beyond that which is currently considered normal.
Water will be able to occupy the large surface area inside the pores and thus be removed. If the solvent could also enter the pores, it would compete with water for the surface area and there would be little or no removal of the water from the bulk solvent. Type 4A molecular sieve is not suitable for drying ethanol, methanol
Because heated blower dryer with molecular sieve dessicant s consume no compressed air for regeneration, this decision allowed for smaller, 150 hp compressors (one being VSD controlled) to be purchased with a smaller 1,500 cfm dryer with molecular sieve dessicant .
Right-size your dryers with molecular sieve – A very large dryer with molecular sieve can affect system efficiency if not properly controlled. However, care should be taken to ensure that dryers with molecular sieve are sized for worst-case conditions; this often requires dryers with molecular sieve to be sized larger than the capacity
molecular sieve desiccant dryers can operate more efficiently by applying dew-point controls. Often, dew-point controls are already installed on a dryer, but nobody has thought to use them.
Externally heated – This type of dryer with molecular sieve uses an externally mounted electric heater that provides hot compressed air for the regeneration process. Because heated air is more effective in driving off the water from the desiccant, a lower flow of purge air is needed – typically about 7.5% of the dryer with molecular sieve
The dryer has controls and a system of valves that will switch towers on a regular basis without interrupting the flow of compressed air with molecular sieve.
Refrigerated air dryers can remove the water vapor from the compressed air, resulting in a dew point at system pressure of about 35 to 40 degrees F, which is adequate for most end uses inside a heated plant. But if the pipes are subject to temperatures below this dew point, water will condense or freeze inside the pipes. Therefore, lower dew points
Submit your requirement and questions
NEWSLETTER SIGNUP
By subscribing to our mailing list you will always be update with the latest news from us.
We never spam!
About Us
Products
Markets
Cases
News
FAQ
Contact Us
Oxygen Sieve Ltihum
Molecular Sieve 3A
Molecular Sieve 4A
Molecular Sieve 5A
Molecular Sieve 13X
Hydrogen Purification 5A
Oxygen Sieve Sodium
Oxygen Sieve 13XHP
XH-Refrigerant Desiccant
Auto Brake Dessicant
Anti Sagging Agent
Molecular Sieve Binder
Anti Settling Agent
Inorganic Gel thickener
Bleach Earth
Suspension Agent
Magnesium Aluminum Silicate
Suspension Thixotropic Agent
Thickener
Thixotropic Agent
ZSM5 Moleuclar Sieve
CaX Moleuclar Sieve
USY Moleuclar Sieve
CaY Moleuclar Sieve
VOC Adsorbent
NaY Moleuclar Sieve
AgX Moleuclar Sieve
Activated Alumina
LiLSX Moleuclar Sieve
Copyright © Mingguang Feizhou new materials Co., Ltd. All Rights Reserved. | Sitemap | Technical Support:
