The material used in an industrial molecular sieve has small uniform pores. When other substances come in contact with the molecular sieve, the molecules that are the right size to fit in the pores will be adsorbed. The molecules that are too large to fit will not.View more
Molecular Sieve is water reactive. Material can react with water liberating extreme heat.The FEIZHOU packet provides protection from direct contact with Molecular Sieve. Avoid using damaged or torn packets.Molecular Sieves are supplied in strips of 6 packets. Each packet contains 12.5 grams. Scissors may be used to cut single unitsView more
the inclusion of Molecular Sieve with processed motion picture film in a sealed container has the ability to extend the life of the dye images and film support beyond that which is currently considered normal.View more
Water will be able to occupy the large surface area inside the pores and thus be removed. If the solvent could also enter the pores, it would compete with water for the surface area and there would be little or no removal of the water from the bulk solvent. Type 4A molecular sieve is not suitable for drying ethanol, methanolView more
Because heated blower dryer with molecular sieve dessicant s consume no compressed air for regeneration, this decision allowed for smaller, 150 hp compressors (one being VSD controlled) to be purchased with a smaller 1,500 cfm dryer with molecular sieve dessicant .View more
Right-size your dryers with molecular sieve – A very large dryer with molecular sieve can affect system efficiency if not properly controlled. However, care should be taken to ensure that dryers with molecular sieve are sized for worst-case conditions; this often requires dryers with molecular sieve to be sized larger than the capacityView more
Externally heated – This type of dryer with molecular sieve uses an externally mounted electric heater that provides hot compressed air for the regeneration process. Because heated air is more effective in driving off the water from the desiccant, a lower flow of purge air is needed – typically about 7.5% of the dryer with molecular sieveView more
By subscribing to our mailing list you will always be update with the latest news from us.
We never spam!